The refrigerator is in the energy-saving mode. In the event of an abnormal temperature rise inside the freezer e. Push the alarm reset button to stop the buzzer sound, while the alarm indicator light will continue to flash. The buzzer will stop automatically when the temperature has returned to normal while the alarm indicator light will continue to flash. Press the alarm reset button. The alarm indicator light goes out and at the same time the freezer temperature indicator show for about 5 seconds the warmest temperature reached in the freezer compartment.
Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brandnew product, then dry thoroughly.
The freezer compartment is suitable for freezing fresh food and storing frozen and deepfrozen food for a long time. However, for a faster freezing operation, turn the temperature regulator toward higher settings to obtain the maximum coldness.
If this occurs reset the temperature regulator to a warmer setting. When first starting-up or after a period out of use, before putting the products in the compartment let the appliance run at least 2 hours on the higher settings. In the event of accidental defrosting, for example due to a power failure, if the power has been off for longer than the value shown in the technical characteristics chart under "rising time", the defrosted food must be consumed quickly or cooked immediately and then refrozen after cooling.
Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator compartment or at room temperature, depending on the time available for this operation.
Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking will take longer. The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired.
This bottle holder shelf can be tilted in order to store previously opened bottles. To obtain this result, pull the shelf up so it can rotate upwards and be placed on the next higher level. There is a separator inside the drawer that can be placed in different positions to allow for the subdivision best suited to personal needs. There is a grille if foreseen on the bottom of the drawer to separate the fruit and vegetables from any humidity that may form on the bottom surface.
To permit storage of food packages of various sizes, the door shelves can be placed at different heights. The Chiller Zone compartment is suitable for storing fresh food like fish, meat, seafood, because the temperature is lower here than in the rest of the fridge. It is placed in the lower part of the refrigerator, directly above of the vegetable drawer. Open the door of the refrigerator as wide as possible.
Pull the drawer towards yourself to the end point. Slightly lift the front part of the drawer. The freezing baskets have a limit stop to prevent their accidental removal or falling out. At the time of its removal from the freezer, pull the basket towards yourself and, upon reaching the end point, remove the basket by tilting its front upwards.
At the time of putting it back, slightly lift the front of the basket to insert it into the freezer. Once you are over the end points, push the baskets back in their position. This is correct. It is natural, not dangerous physical phenomenon. If this happens, set the Temperature Regulator toward warmer settings to allow automatic defrosting and so a saving in electricity consumption. Meat all types : wrap in polythene bags and place on the glass shelf above the vegetable drawer.
Cooked foods, cold dishes, etc.. Fruit and vegetables: these should be thoroughly cleaned and placed in the special drawer s provided. Butter and cheese: these should be placed in special airtight containers or wrapped in aluminium foil or polythene bags to exclude as much air as possible.
Milk bottles: these should have a cap and should be stored in the bottle rack on the door. Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator. To help you make the most of the freezing process, here are some important hints:. No further food to be frozen should be added during this period;. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians.
Never use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as this will damage the surface and leave a strong odour. Clean the condenser black grill and the compressor at the back of the appliance with a brush or a vacuum cleaner. This operation will improve the performance of the appliance and save electricity consumption. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added.
Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates.
It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside.
Use the special cleaner provided, which you will find already inserted into the drain hole. The freezer compartment of this model, on the other hand, is a "no frost" type. This means that there is no buildup of frost when it is in operation, neither on the internal walls nor on the foods. The absence of frost is due to the continuous circulation of cold air inside the compartment, driven by an automatically controlled fan.
Only a qualified electrician or competent person must do the troubleshooting that is not in this manual. As much as the advice does not lead to result, call the nearest brand-mark service. Connect the plug to the mains socket. Open the door.
Make sure that the light comes on. If necessary, adjust the door. Refer to "Installation". If necessary, replace the defective door gaskets.
Contact the Service Force Center. The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label.
Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance. Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance:.
The appliance should be installed well away from sources of heat such as radiators, boilers, direct. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below. Accurate levelling is ensured. Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply.
The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a qualified electrician. The manufacturer declines all responsibility if the above safety precautions are not observed.
In the bag with the documentation, there are two spacers which must be fitted as shown in the figure. Slacken the screws and insert the spacer under the screw head, then tighten again the screws.
To carry out the following operations, we suggest that this be made with another person that will keep a firm hold on the doors of the appliance during the operations. Open the doors. Unscrew the middle hinge m2. Remove the plastic spacer m1.
Remove the spacer m6 and move to the other side of the hinge pivot m5. Remove the left-hand cover pin of the middle hinge m3,m4 and move to the other side. Fit the pin of the middle hinge m5 into the left-hand hole of the lower door. Remove using a tool the cover b1. Unscrew the lower hinge pivot b2 and the spacer b3 and place them on the opposite side. Re-insert the cover b1 on the opposite side. Reverse the door locking elements d2,d3 , move to the other side of the other door and fix by screwing in the screw d4.
Re-insert the stoppers d5,d6 on the other side of the doors. Insert the middle hinge m2 into the left drill of the lower door. Unscrew the upper hinge pivot t1 and. Fit the upper door on the upper door pivot. If the ambient temperature is cold i. In that case, wait for the natural fitting of the gasket. In case you do not want to carry out the above mentioned operations, contact the nearest After Sales Service Force. The After Sales Service specialist will carry out the reversibility of the doors at your cost.
Please contact your supplier in the event of damage. A damaged power plug may overheat and cause a fire. There is a risk of electric shock or fire. The refrigerant isobutane Ra is contained within the refrigerant circuit of the appliance, a natural gas with a high level of environmental compatibility, which is nevertheless flammable. Danger of suffocation! Keep packaging materials away from children! Remove plug from mains, sever the power cable, remove or destroy any snap or latch closures.
This eliminates the danger that playing children lock themselves into the appliance danger of suffocation! Please provide for the necessary supervision and do not allow children to play with the appliance! Danger of explosion! Do not store containers with flammable substances, such as aerosol cans, refill cartridges for cigarette lighters etc.
They can burst when the contents freeze - or even explode if the contents contain carbonic acid! Never place sodas, juices, beer, wine, champagne etc. Exception: Spirits with high alcohol content may be stored in the freezer compartment. Very cold ice can freeze to the lips or tongue and cause injury.
Hands can freeze to the goods. Electronic components are housed within this cavity. If condensate should drip onto these components, the appliance could be damaged by a short circuit. For this reason do not place frozen goods on top of the appliance.
There is a risk of a short circuit and fire. If the instructions in this section are not sufficient, do not undertake any further work on your own. Repairs carried out by untrained personnel can lead to substantial danger. Please contact your dealer or our customer service department for repairs.
All transit packaging materials are environmentally compatible and can be reused. Wood is un-treated. The plastics can be recycled and are identified as follows:. The carton parts are made from recycled paper. Please dispose of the packaging with due care for the environment.
For environmental reasons, refrigeration appliances must be disposed of properly. This applies to your old appliance, and - at the end of its service life - for your new appliance as well. Before disposing of old appliances make them inoperable. Two persons are required for transport of the appliance. There are two recessed handles at the back of the appliance at the top for improved gripping.
Grip the appliance with the recessed handles positioned as in the drawing, and transport the appliance. In order to push the appliance into its final position, press carefully at the top of the door and tip the appliance back slightly. The weight is thus transferred to the back wheels and the appliance can be easily pushed. Remove all adhesive tape and packaging from the interior of the appliance. Remove the transport protection pieces and pull off the adhesive tape.
Energy use and efficient performance of the appliance is affected by the ambient temperature. The climate classification can be found on the rating plate, which is located at the left on the inside of the appliance. The following table shows which ambient temperature is correct for each climate classification:. If installation next to a source of heat is unavoidable, the following minimum clearances must be maintained at the sides of the appliance:.
If these clearances cannot be maintained a heat insulating pad is required between the cooker and the refrigeration appliance. Air is fed under the door through the vent slots in the base and is exhausted upwards along the back wall. To ensure proper air circulation never cover or alter the vent openings.
If the appliance is installed under a hanging cabinet, a clearance of at least 10 cm between the top of the appliance and the cabinet above it must be maintained. Please check whether, after installing your appliance and especially after reversing the door, the door seal seals tightly. Remove the two wall spacers from the appliance accessories pack and insert them into the heat exchanger bars condenser located at the top of the rear of the appliance as per the illustration, so that the distance between the back of the appliance and the wall that is required for correct ventilation is ensured.
The appliance must be level. Please compensate for unevenness in the floor by turning the two adjustable feet at the front. Welcome to ManualMachine. We have sent a verification link to to complete your registration. Log In Sign Up. Forgot password? Enter your email address and check your inbox. Please check your email for further instructions. Enter a new password.
Dear customer, Before placing your new appliance into operation please read these operating instructions carefully. Printed on paper manufactured with environmentally sound processes. Contents Safety. Refrigerant The refrigerant isobutane Ra is contained within the refrigerant circuit of the appliance, a natural gas with a high level of environmental compatibility, which is nevertheless flammable.
Environmental Information Packaging All transit packaging materials are environmentally compatible and can be reused. Old Appliances For environmental reasons, refrigeration appliances must be disposed of properly.
0コメント